Security door stopper – You just bought a new stainless steel refrigerator. It looks great nestled between classy cherry cabinets and doors of your roof deck with views of the city. Then, it looks perfect now, but it only takes an overzealous or over-intoxicated house guest to swing the door wide and dent the façade of your new purchase. It is situations like these that doorstop was invented.
Wall bracket, these security door stopper are perfect for homes that have hard floors that do not allow a floor mount stop. The wall bracket is very similar baseboard door stop and also install almost identical. To install these doors clots, locate the place where the door comes into contact with the wall. And then, place the stop wall 3-4 inches from the floor and about 1 inch from the latch side of the door. Drill a hole in the wall and screw stop in.
And then, BMC security door stopper, this stop is good for heavier doors. To install these doors clots, first figure out “sweep” of the door. Then, precise location of BMC, where it comes in contact with the door. About 1 ½ inches in from the edge and bottom of the door. This is where you should install your stop. Then, this will prevent the door from the stop punching a hole in a hollow door. Drill a 1/8 inch hole in the BMC. Screw the doorstop.